I say this because I'm not sure what you're trying to connect to with the private IPv4 address. Looking at the documentation closer, I think I'd need to know more about what you're trying to accomplish. Hello again Following up on your response to our tweet, in which you said: Ultimately, you may have to reach out to () to best assist you if their documentation doesn't provide what you're looking for. >Thanks for the reply Team! Sadly Mikrotik SSH doesn’t allow commands such as those you’ve documented. Ultimately, you may have to reach out to MikroTik's Support team to best assist you if their documentation doesn't provide what you're looking for.ĭescription Hello again Following up on your (), in which you said: How to link Public addresses to Local ones It's seemingly the opposite of what you're looking to do, but I thought to reverse the commands may help you get to where you need to go.

It looks to be a guide for making privately assigned IPs publically available. The following link is a section from their Wiki that I was able to locate that discusses private interfaces. I found this page in their documentation, which covers IP addressing, though I believe it's more geared toward their routers, rather than RouterOS: Private IPs only connect across the private network of the data center and cannot connect to any external network. Thanks for the reply Team! Sadly Mikrotik SSH doesn’t allow commands such as those you’ve documented. This guide helps walk through the steps needed to complete this process. You would have also needed an installer disk in addition to a boot profile. This Mikrotik Documentation provides a helpful manual to use chr on Linode. If you'd like further assistance, let us know where you got stuck and what errors you are encountering.

() helps walk through the steps needed to complete this process. This () provides a helpful manual to use chr on Linode.

Chr mikrotik vps